Blasterparts - Modification spring for NERF Longshot CS-6

No other blaster becomes as formidable as the Nerf N-Strike Longshot due to a simple spring replacement!

No. 560594

Combined with a Modification Spring the Nerf N-Strike Longshot is THE Nerf blaster

If you can call a Nerf N-Strike Longshot your own than you possess a piece of Nerf history. The very first blaster to hold the designation “CS-6” – “Clip System 6”. There have been quite a few magazine blasters since then but Nerf modders everywhere love the Longshot the most. Not because it features awesome stock ranges – those are actually quite mediocre. What is great is the Longshot’s potential. Throw a Modification Spring in there and you will be hard pressed to find a blaster that can hold its own against the Longshot.

Features of the Modification Spring for the Nerf Longshot

Equivalent mass of spring: 9kg
Firing range increase: about 150%
Muzzle velocity increase: about 100%
difficulty level of spring installation: moderate

Enormous ranges for little effort

The spring-replacement itself is rather easy – the blaster’s internals are a bit complex, though. Take an internal picture or two so you will know where everything goes.

Once the blaster is open you will have to remove the large orange tube. This is the “plunger tube”. On its backside you will find two silver screws – remove these as well to find the stock spring inside. There is one more screw to go on the front of the plunger. Now you just need to replace the original spring with the Blasterparts Modification spring, close everything back up and you are done!

Included in delivery

Modification Spring, Manual

Age recommendation: From 14 years.

Attention! This product is not a toy. Keep out of children?s reach.

This product is not a product of the manufacturer or importer of the dart blaster designated as compatible. Modifying and changing a blaster with the components offered here is at your own risk and may lead to increased wear and tear on other components.

show less

Write a review